Washers, Locknuts, and Plugs

Brass 1/4" Hex Plug for gas regulators.

Helps keep beer taps clean. Protects taps from fruit files and contamination when not in use. Eliminates the time and waste for wrapping beer taps...

Clear 1/4" Nylon Flare (MFL) Washer for Regulators These should be used whenever there is a metal to metal flare connection.

When you’re working with homebrew kegs, this handy adapter makes quick disconnection easy. Simply utilize the corny plug adapter with your existing...

Use this stainless steel 1/2" female NPT cap to plug an unused 1/2" NPT nipple.

High quality neoprene construction. Required wherever you use a tail piece with a shank hex nut.

High quality neoprene construction. Required wherever you use a tail piece with a shank hex nut.

Easily plug 220 volt brewing equipment into the same plug you use for your stove/oven. Compatible with the G30/G40/G70. Fits most standard sto...

This hex locknut is a stainless steel cast pipe fitting with female National Pipe Taper (NPT) threads for locking two fittings into place for stabi...

Dust Plugs are used with Type B, C and D Couplers to seal the end of the connection

Similar in principle to the Jet washer, but with the exception of the faucet coupler, all parts are made of sturdy plastic, which will never corrod...

Stainless Steel 7/8" Washer.

Washers for use with the EZ Filter. EZ Filter washers are made from 'spirit resistant' polyethylene so they will not taint the spirit. Use one at ...

This square head plug has 1/2" NPT threads and is made from 304 stainless steel. It can be used to plug any of the 1/2" NPT couplers Spike welds o...

The Ss Brewtech 22mm Compression Fitting Plug is made out of 304 Stainless Steel. It is intended for use with plugging 22mm holes in your Ss Brewte...

Food Grade Polyethylene Washers designed for the Air Still Filter. Ideal for use with alcohol as Polyethylene will not taint spirits. Change washer...

The Ss Brewtech 17mm Compression Fitting Plug is made out of 304 Stainless Steel. It is intended for use with plugging 17mm holes in your Ss Brewte...

Cone plug seal for the GF30 Conical Fermenter, to prevent leaking when the Dual Valve Tap is not being used with the fermenter.

Stainless Steel 1/2" Hex Plug.

Replacement faucet gasket/washer

Beer faucet ball washer.

Replacement faucet gasket/washer to repair loose beer faucet lever.