Penguin Chillers | Cold Therapy Chiller Package

Package includes:

• Plug & Play – No tools required
• 7,500 BTU/hr
• 5 micron filter
• Quick Connect hoses
• 1 Year Product Warranty
• Proudly made in the USA
• OPTIONAL: Ice Barrel option adds the fittings specific for hooking up to an Ice Barrel 

*Ice Barrel sold separately. 

Whether you are new to cold therapy or a seasoned pro, you are likely doing it for the benefits that exposure to cold offers rather than the physical workout you’ll get from lugging all the ice needed to keep up with it.  Let's face it – keeping up with the amount of ice needed to keep an Ice Barrel cold can get to be quite the burden.  Our chiller will keep your Ice Barrel cold effortlessly, this should lead to more consistent and frequent usage. Make the most out of your Ice Barrel by turning it into an Iceless Barrel!

The chiller can reach into the low 40F’s, even down into high 30F’s with the right conditions.  Ambient temps and sun exposure account for the majority of the heat load on a cold therapy tub (your body heat is insignificant  compared to the sun).  Reducing the external heat load will improve chiller performance.  Low to mid 40F’s should be possible on an Ice Barrel setup even in full sun / less than ideal conditions.

CHILLER SPECS.

• 3/4HP High Efficiency Chiller
• 7,500 BTU/hr
• 56 dBA (fairly quiet)
• 110 – 120 Volts / 450 Watts / 3.9 Amps
• 14”W x 20”D x 12”H
• 52 Pounds
• Built in Pump
• 10′ power cord with GFCI protection
• Rain Proof* (*disconnect chiller and drain completely when ambient temps are freezing or below to prevent damage to chiller)
• 1 Year Product Warranty
• Proudly made in the USA

Note:  The chiller is not weather rated, it needs to be protected from rain/water.  The pump and filter are waterproof and can be installed outdoors

Cost to Run (lower than you’d expect):

At $0.12/KWh the monthly cost of operation should be around $18-$28/month.  The compressor and fan only turn on when cooling is needed, once the water reaches your set point they turn off and only the low wattage pump continues to run.

A common question we get revolves around setting the chiller up on a timer. Ideally, you’ll want to keep the water cold at all times. There are a few reasons for this –

1. Cold water keeps bacteria (slimy walls) largely under control by slowing or stopping their growth.  This significantly reduces the amount of maintenance needed to keep your water clean for longer periods of time. This means less frequent water changes and that much lower levels of sanitizer being an effective dose (chlorine/hydrogen peroxide/etc.).
2. If you are using it on a regular basis the amount of potential power savings will be fairly insignificant, the heat it would gain in the “off” period still needs to be removed when you turn it back on. So, if running is normally cost $18-$28/month you might be able to save $3-$5/month. However, you will have to change water and the filter more often, so it is unlikely to be a net cost savings.
3. When you cut power to the chiller you also cut power to the pump.  Pumps get the most wear and tear during startup, that’s when a pump is most likely to fail as well. Cycling the power to the chiller is just adding unnecessary wear and tear to the pump.